![]() # parameter to ‘yes’ if you want to be able to write to them. # By default, the home directories are exported read-only. # to make sure that only “username” can connect to \\server\username # By default, \\server\username shares can be connected to by anyone # user’s home directory as \\server\username # to enable the default home directory shares. # Un-comment the following (and tweak the other settings below to suit) To share the home directories, open up smb.conf with the following command:įind this section of the file, and make it match the following: This can be useful so that you don’t have to manually create every share for every user.įirst, make sure that you’ve installed Samba server. Sites are unable to avoid such configurations, and these sites should review the ldap replication sleep parameter, intended to slow down Samba sufficiently for the replication to catch up.Samba Server allows you to share the home directories of users automatically. Machine account is created on the LDAP server, but the password fields will be empty. Note: there are two shared items at the bottom. Replace the contents of that file with the code below. Edit the smb.conf as follows (adjust this to suit your Linux environment and editor): sudo gedit /etc/samba/smb.conf. Therefore gives an error message on the client machine about not being able to set up account credentials. Here’s a very simplified smb.conf for Samba which you can try if you are having problems with Samba in your home network. This is not replicated rapidly enough to the slave server that the PDC queries. Global smb.conf options stored in registry are used. Shares defined in smb.conf take priority over shares of the same name defined in registry. ![]() The registry shares are loaded not at startup but on demand at runtime by smbd. ![]() Will fail in this configuration because the change to the machine account in the LDAP tree must take place on This is triggered by setting the global parameter registry shares to 'yes' in smb.conf. Slapd.pem file with hostname “ localhost.localdomain.” It is impossible toĪccess this LDAP server from a slave LDAP server (i.e., a Samba BDC) unless the certificate is re-created withĭo not install a Samba PDC so that is uses an LDAP slave server. The Red Hat Linux startup script creates the Name in /etc/ssl/certs/slapd.pem must be the same as in When using an OpenLDAP server with Transport Layer Security (TLS), the machine It does not really fit within the scope of this document, but a working LDAP installation is basic to On server certificate names are in RFC2830. Must use the CN attribute to name the server, and the CN must carry the servers' fully qualified domain name.Īdditional alias names and wildcards may be present in the subjectAltName certificate extension. It must be noted that the DN of a server certificate When configuring a master LDAP server that will have slave LDAP servers, do not forget to configure this in Then again, it is entirely possible to use a single LDAP server for the Many administrators will want to do so in order to provide redundant services. The smb.conf file is broken into sections. After Samba is installed the smb.conf file will be around 533 lines long. It is not essential to use slave LDAP servers however, When you compare what you need vs what you have (in the default at least), you will be surprised at how simple Samba can be to configure. When configuring a master and a slave LDAP server, it is advisable to use the master LDAP serverįor the PDC and slave LDAP servers for the BDCs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |